Brushes for the Food Sector
Our brushes for food use are produced based on specific designs using materials and colours in full compliance with the sanitary provisions laid down by national and international regulations.
- Brushes for the food sector
Circular brushes punched with filaments suitable for contact with food. The staple that holds the filaments is fitted into the brush body and is made by stainless steel AISI 304. These brushes can be produced in one piece only or with segments with toothed faces to permit to join together several segments to get a long brush. Segments are used when the dismounting area in the machine is tight. If there is not space problem, a single body is preferred.
- Brushes for the food sector
Circular punched brushes divided into two pieces. This brush made by two semi-shells is joined together by screws and borns from the need to replace it without removing the shaft. The main disadvantage for such solution is that filaments are missed at the junction point of the two shells.
- Brushes for the food sector
Flat punched brushes to let adhere products when packaging by film, envelopes or cartons.
- Brushes for the food sector
Punched block brushes to be mounted on chains or belts. The base is machined to get threaded holes and anchors. In this way the brush can be dismounted from the chain and easily replaced when worn out while the chain remains on the machine.
- Brushes for the food sector
Linear brushes punched entirely made in blue plastic. Depending on the type of filament used, the brush can retain, scrape, filter or move materials.
- Brushes for the food sector
Circular punched brushes with inclined blades to get, according to the rotation speed applied, the possibility to move materials, to allow passage of air or to separate different products from each other.
- Brushes for the food sector
Flat brushes, punched on the ends with different diameters and types of filaments to have a double effect in a single brush.
- Brushes for the food sector
Circular punched brushes with plastic body and inner stainless steel or aluminum tube. This system makes stiffen the plastic body of the brush with a small diameter permitting a maximum length of 1500 mm.